Driveline Installation - Woods BRUSHBULL BB600XE Manual Del Usuario

Category I Quick Hitch Set-Up
1. Tractor top link
2. Cutter top link attachment point
3. Floating link
5. Category I & II cutter hitch pin
6. Brace arm
7. A-frame arm
CONNECTING AND REMOVING
DRIVELINE (TRACTOR PTO)
To Install:
Pull locking collar back and at the same time push driveline onto tractor PTO
shaft until locking device engages.
To Remove:
Hold driveline into position, pull locking collar back, and slide driveline off trac-
tor PTO shaft.
Figure 4.

DRIVELINE INSTALLATION

Attach the cutter to the tractor 3-point hitch (or quick hitch if available). Do not
attach driveline. Raise and lower cutter to determine maximum and minimum
distance between the tractor PTO shaft and the gearbox input shaft. If the dis-
tance is too large, the driveline will be too short for proper engagement. If dis-
tance is too small, the driveline may bottom out in operation and damage the
cutter or tractor.
The driveline length must be sufficient to provide at least 1/3 driveline length of
engagement during operation. There must be at least 101.6 mm (4 inches) of
engagement at the cutter's lowest possible point of operation. The driveline
must not bottom out when raised to the maximum height possible.
MAN1255 (3/19/2018)
Figure 3.
Lock Collar
Category II Quick Hitch Set-Up
8. Quick-Hitch
9. Rear lug
10. Brace arm pivot hole
12. Break link
13. Second hole on pivot hole
15. Mast plate
Quick Hitch Set-Up
If driveline is too short, please call your Woods dealer for a longer driveline.
If driveline is too long, please follow the instructions for shortening the driveline.
SHORTENING DRIVELINE
1.
Move cutter up and down to get the shortest possible distance between
tractor PTO shaft and gearbox input shaft.
2.
Separate driveline into two halves and connect them to the tractor PTO
and gearbox.
3.
Place driveline halves parallel to one another to determine how much to
shorten the driveline.
DP2
Figure 5.
4.
Measure from end of the upper shield to the base of the bell on the lower
shield (A). Add 34.69 mm (1-9/16") to dimension (A). See Figure 6.
Drive Halves Placed Parallel
Operation 9