Bellman & Symfon AUDIO DOMINO CLASSIC BETXAUD2 Manual De Instrucciones página 317

Testing
It is easy to test the Bellman Audio Domino Classic Personal Hearing System. If
the Bellman Audio Domino Classic does not operate as described below, you
can carry out further troubleshooting as instructed under Troubleshooting.
How to test
The testing of Bellman Audio Domino Classic has been divided into three parts.
One part for the Receiver Unit for which only the Receiver Unit is required, one
part for the Transmitter Unit for which both units are required and finally one
for charging the two units.
Receiver Unit
• Switch on the unit and make sure that the Battery Status LED (3) lights up green.
• Connect the headphones to the Headphone Socket (13) and scrape carefully
on the round microphone (1) with your finger and check that there is a scraping
sound in the headphones.
• Press the buttons (9, 10, 11, 12) and check that the Volume and Tone Indicator
changes.
Transmitter Unit
• Switch on the unit and make sure that the Battery Status LED (17) lights up green.
BE2250_001MAN005_book.indb 317
APP
317
2017-06-13 16:42:18