Tools And Materials; Before You Begin - Kohler K-18486 Guía De Instalación Y Cuidado

Tools and Materials

Strap
Wrench
Drill and
Hole Saw
Hacksaw or
Tubing Cutter Thermometer

Before You Begin

NOTE: This product may be installed as freestanding (installed
onto riser tubes) or deck-mount (installed onto the bath deck).
Follow the sections that pertain to your installation.
For Freestanding Installations
NOTICE: Discard the following hardware provided with the bath
filler: support plate (1), threaded brass tubes (2), nuts (4), fiber
washers (4), and screws (8).
NOTICE: Do not remove the protective wrap from the riser tubes
until instructed to do so.
For All Installations
Observe all local plumbing and building codes.
Shut off the water supply.
IMPORTANT! For proper drainage of the spout, install the bath
filler to a level surface.
1219580-2-A
Sealant Tape
Solder
Plus:
• Two 1/2" NPT Male
Copper Connectors
• Two 12" (305 mm) Long,
1/2" Copper Tubes (Deck-Mount)
• Two 30" (762 mm) Long,
1/2" Copper Tubes (Freestanding)
2
3 mm,
5/16", 1/4"
Kohler Co.