Charging The Battery Using An External Battery Charge; Control Panel - Ghibli & Wirbel FR30 TOUCH Serie Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
5.1.b - Charging the battery using an
external battery charger (Fig.
8)
WARNING:
It is important to first connect the plug (35)
to the socket (44) of the battery charger
and then connect the battery charger to
the mains socket, otherwise the batteries
will not charge.
- Move the machine close to the battery
charging station.
- Remove the battery plug (35) from the
system socket (39).
- Connect the battery plug (35) to the ex-
ternal battery charger socket (44).
- Once battery charging is complete, re-
connect the battery plug (35) to the sys-
tem socket (39).

6.1 CONTROL PANEL

(Fig. 9)
WARNING:
Before using the machine you must se-
lect the washing cycle as shown in the
relevant paragraph.
20) Sensor for starting the traction and
brush rotation
• (for model with traction)
Check the display so that the minimum
traction speed is set.
By operating the sensor (20) with the
button (45) "
" and the button (51) "
traction and brush rotation will start and
also the water supply.
The machine will start forward automati-
cally; by pressing and holding down but-
ton (48) " " whereas activating lever
(20) the machine will start in reverse.
To move in reverse, lift the wiper.
", the button (52) "
" ipressed, the
20) Sensor for starting brush/es rotation
• (for model with traction)
By operating the sensor (20) with the
button (45) "
" and the button (51) "
traction and brush/es rotation and water
supply will start.
45) Main switch "
By pressing the button, voltage is insert-
ed in the circuits allowing the operation
of commands and of the appropriate but-
tons; the display (46) will turn on.
Press the button again to disconnect the
voltage from the circuits.
46) Display
It lights up after the voltage is supplied to
the circuits using the button (45) "
The display indicates the machine status,
battery charge, working hours and alarm
messages.
47) Speed control buttons
(for model with traction only)
Button (47a) "
Pressed, increases the traction speed.
Button (47b) "
Pressed, decreases the traction speed.
The display (46) indicates the set speed.
48) Reverse button "
(for model with traction only)
Check the display so that the minimum
traction speed is set.
Pressed and held down while operating
the sensor (20) , the machine will start to
go backwards towards the operator. The
display will show the following symbol
" ".
ENGLISH - 7
", the button (52) "
" pressed, the
"
".
".
"
".