Working Cycle Example - Ghibli & Wirbel FR30 TOUCH Serie Uso Y Mantenimiento

50) Aspirator start button "
Button operation is enabled by pressing
the button (45) "
Press the button (50) "
will start to function; the symbol "
pears on the display.
To turn off the aspirator, press the button
(50), the turbine will continue to function
for a few seconds in order to aspirate the
liquid on the floor, afterwards it will turn
off automatically. The symbol "
disappear from the display
49) Silent operation button "
Pressing the button (49) "
the speed of the intake turbine, which
considerably reduces the machine noise
; the symbol "
with the function enabled.
Pressing again button (49) "
the function and the machine will start to
operate again in standard mode; symbol
" " appears on the display.
NOTE:
When turning off the aspiration turbine with
"silent operation" mode enabled, the opera-
tion of the turbine will automatically switch
to "standard operation" mode for the entire
shut-off delay time.
51) Water solenoid valve button "
Button operation is enabled by pressing
the button (45) "
".
Press the button (51) "
will show the symbol "
ing of the water solenoid is being pre-
pared. Its operation is controlled by the
sensor (20).
The water quantity can be adjusted using
the tap (4).
"
".
", the aspirator
" ap-
" will
"
" reduces
" appears on the display
" turns off
" and button (52) "
", the display
", and the open-
To stop water dispensing, press the but-
ton (51) "
52) Brush rotation enable button "
Button operation is enabled by pressing
the button (45) "
Press the button (52) "
brush rotation will be activated; the dis-
play will show the symbol "
operation is controlled by the sensor (20).
To stop brush rotation, press the button
(52) " ".
4) Water quantity adjustment tap
- Turn the tap (4) counter-clockwise to
increase the quantity of water or turn it
clockwise to decrease it.
6.2 WORKING CYCLE EX-
AMPLE
Setting a washing cycle with brushes and
drying.
- Press the button (51) to allow the water
supply.
- Press the button (52) to allow brush rota-
tion.
- Press the button (50) and the vacuum will
start.
NOTE:
In special environments it is possible to acti-
vate the noise reduction function by pressing
the button (49).
"
WARNING:
At startup be careful not to touch the
touch sensor (20); the machine will go to
alarm mode.
If you release the sensor within two sec-
onds, the alarm will automatically turn off
and after more than two seconds you will
need to stop and restart the machine.
ENGLISH - 8
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
".
".
", and the
". Brush/es
(Fig. 9)
"