Selection And Variation Of The Speed; Packing And Handling; Starting The Tool; Stopping The Tool - CAMPAGNOLO STARBERRY MD1 Manual De Uso Y Mantenimiento

4.2

Selection and variation of the speed

Keep the trigger (26) pulled.
•
Press the + button (24) on the keyboard to increase the vibrating frequency up to max. 2200 strokes/minute, or press
•
the – button (25) to decrease the vibrating speed till min. 600 strokes/minute.
The selected speed remains memorized even after releasing the trigger (26).
•
4.3

Packing and handling

The unit is packaged by the Manufacturer and shipped inside a carrying case.
WARNING!
The handling of loads must be carried out in compliance with the current safety rules in the workplace.
5.1

Starting the tool

Before starting the tool, wear protective clothing as shown in the picture and check that all safety and protection systems
are correctly functioning and assembled.
Put on the backpack (12) (picture B) and adjust the length of the belt by means of the specific buckle (14).
•
The backpack (12) must be positioned so that 90% of the weight is supported by the operator's waist
•
and not by his back (picture B).
•
The braces (15) should be used to better balance the weight.
•
Adjust the buckle (13) on the braces (15), so that they cannot slip off your shoulders
•
Put on the armband (17), so that the cable (19) cannot interfere in the shaking operations of the tool.
•
Hold the tool and press with your free hand first the battery-switching-on button (8), then the tool one (22).
•
At every re-start after switching off the battery (1), the "system" must be calibrated (see par. 4.1)
•
Carefully insert the branch into the tool pole (29) with hooks (30) and pull the trigger
•
WARNING!
Do not press excessively the trigger (26). It would not increase the tool power.
WARNING!
Always use adequate clothing as called for by the job. Wear tight clothing. Do not wear ties, necklaces or belts
which may get caught in the moving parts. Use googles, safety shoes and antivibration gloves.
When holding the tool in your hand, carry out the following operations in sequence:
a) Carefully insert the branch into the hooks (30) of the tool pole (29) and pull the trigger (26).
b) If the set vibrating frequency is effective to make the fruits fall down, release the trigger (26) and carry on with the
following branch, performing the operation in point a). Otherwise, perform the operation in point c).
c) Keeping the trigger (26) pulled, adjust the right speed using the + and – buttons (24) y (25) on the tool body (21). Then
go on repeating the operation described in point a).
WARNING!
Remember that the charge value of the battery pack (1) is approximate. We recommend recharging the battery (1)
at the end of each workday, even if it is still partially charged.
WARNING!
Remember that failure to perform the intended inspections at an Authorised Service Point of the Manufacturer
makes the warranty void (see par. 1.5).
WARNING!
• The tool shall be used for the purposes described in par. "Product Description" only. Other uses could cause
injuries and/or damages.
•
Start the tool only when inserted between the branches. Improper use causes greater wear-and-tear and does
not allow to save the battery power.
5.2

Stopping the tool

The tool must always be switched off at the end of any working session:
•
Press the ON-OFF button of the tool (22) and of the battery (8).
•
Carefully place the tool without bending or tensioning the connector (5) and the power supply cable (19).
•
Do not crush the cable (19) by placing weights or the tool onto it.
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 02/04/2020
(26).
Pag. 25