ISO DIN radio provision with pocket
1. Mount the pocket to the radio
brackets with (4) #8 x 3/8" Phillips
screws supplied. (Figure A)
2. Mount the bracket/pocket
assembly to the radio housing trim
panel with (4) included #8 screws
(Figure B)
3. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
4. Slide the radio into radio brackets
and secure with screws supplied
with the radio. (Figure C)
5. Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the radio for
proper operation.
6. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
(Figure C)
99-9227
ISO DDIN radio provision
1. Attach the brackets to the radio
housing trim panel using (4)
#8 x 3/8" screws supplied.
(Figure A)
2. Slide the radio into the bracket/
radio housing assembly and secure
to the assembly using the screws
supplied with the radio. (Figure B)
3. Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the radio for
proper operation.
4. Reassemble the dash in reverse
order of disassembly.
3
(Figure A)
(Figure B)