Publicidad
Idiomas disponibles
Idiomas disponibles
LP Tank Exchange
Connecting
Regulator To The LP Tank
• Many retailers that seii griiis offer you the option of replacing
your empty LPtank through an exchange service. Use only those
reputable exchange companies that inspect, precision fill, test
and certify their cylinders. Exchange your tank only for an OPD
safety feature-equipped
tank as described in the "LPTank"
section of this manual.
• Always keep new and exchanged
LPtanks in upright position
during use, transit or storage.
• Leak test new and exchanged
LPtanks BEFORE connecting to
grill.
1. LPtank must be properly secured onto grill. (Refer to
assembly section.)
2. Turn all control knobs to the OFF position.
3. Turn LPtank OFF by turning OPD hand wheel clockwise to a
full stop.
4. Remove the protective cap from LPtank valve. Always use
cap and strap supplied with valve.
LP Tank Leak Test
For your safety
• Leak test must be repeated each time LPtank is exchanged or
refilled.
• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Grill must be leak tested outdoors in a well-ventilated
area,
away from ignition sources such as gas fired or electrical
appliances. During leak test, keep grill away from open flames
or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution. Brush soapy solution onto areas indicated by arrows
in figure below. Leaks are indicated by growing bubbles.
Safety Relief
/
Strap and Cap
Hand Wheel
rpe 1 outlet with
thread on outside
If "growing" bubbles appear do not use or move the LP
tank. Contact an LPgas supplier or your fire department!
• Do not use household cleaning agents. Damage to the gas
train components
(valve/hose/regulator)
can result.
Do not insert a POL transport plug
(plastic
part with external
threads) into the type 1 valve
outlet. It will defeat the Safety
Relief Valve feature.
5. Hold regulator and insert nipple into LP
tank valve. Hand-tighten the coupling
nut, holding regulator in a straight line
with LPtank valve so as not to crossth-
thread the connection.
Nipple
has to be
centered into the LP
tank val
6 ° 34461-41600070
Publicidad
