Metrix HX0102 Manual De Instrucciones página 25

Chapter II
„ Do not use the probe if it is open, damaged, or incorrectly reassembled.
„ Do not expose the probe to sprays of water.
„ Connect the probe only to oscilloscopes of which the overvoltage category and service voltage are
greater than or equal to those of the device.
„ Keep away from other conductors that might induce extraneous fields.
„ For the replacement of the battery, the probe must be completely disconnected and the switch must
set to OFF.
„ All troubleshooting and metrological checks must be done by competent, accredited personnel.
1. PRESENTATION ...........................................................................................................................26
1.1. Probe .................................................................................................................................26
1.2. Mains adapter ....................................................................................................................27
2. CURRENT MEASUREMENT .......................................................................................................28
2.1. Measurement principle ......................................................................................................28
2.2. Use ....................................................................................................................................28
2.3. Mains adapter ....................................................................................................................31
3. CHARACTERISTICS ....................................................................................................................32
3.1. Reference conditions .........................................................................................................32
3.2. Electrical characteristics....................................................................................................32
3.3. Variations within the range of use .....................................................................................34
3.4. Frequency response ..........................................................................................................36
3.6. Power supply .....................................................................................................................38
3.7. Environmental conditions ..................................................................................................38
3.8. Characteristics of construction .........................................................................................38
3.9. Compliance with international standards ..........................................................................39
4. MAINTENANCE ............................................................................................................................40
4.1. Cleaning.............................................................................................................................40
4.2. Replacement of the battery ...............................................................................................40
4.3. Metrological check ............................................................................................................41
4.4. Repair ................................................................................................................................41
5. WARRANTY, SERVICE .................................................................................................................42
6. TO ORDER ....................................................................................................................................42
6.1. Spare parts ........................................................................................................................42
Oscilloscope current probe
CONTENTS
25