Installation In Rack (Shown For 16U Frame) - Eaton Pulsar Serie Manual De Instalación Y De Usuario

2.4

Installation in Rack (Shown for 16U Frame)

MX Frame Rack Mounting Kit
Telescopic rails for MX Frame mounting in 19'' enclosure with mounting hardware
The battery sub-modules and power sub-modules must not be mounted yet.
i
Do not install the UPS or battery module in a closed environment without air circulation.
Follow steps 1 thru 4 for rack mounting the UPS onto the rails.
1. Attach both front mounting brackets to MX Frame with supplied screws. (For this step, it is possible to adjust the position
of both front mounting brackets.)
2. Attach telescopic rails (37) together, secure with wing nuts, and finger tighten (both sides).
3. Attach both rails to rear and front of rack with supplied flathead screws (as shown).
4. Use caution when sliding unit into rack. Temporarily secure unit to rack with thumb screws on front mounting brackets.
The rails and the necessary mounting hardware are supplied by EATON.
i
86-87021-00 A01 - Page 16
16U Frame shown
(35) Front mounting brackets
(37) Telescopic rails, 27.36'' to 39.96'' length
(639 mm to 1005 mm)