Publicidad
Idiomas disponibles
Idiomas disponibles
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural
members, etc. CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle
manufacturer changes; however, it is ultimately the responsibility of the installer to prevent damage due to
14.
Drill pilot hole in truck bed per measurements. With hole saw or knockout punch in large hole to 3-1/4".
Plastic bed liner will need to be removed before drilling or punching out. Bed liner will need to be cut as noted
in general instruction #3 on page 5. Optional: Spray under coating around 3-1/4" holes to prevent rusting.
15.
Loosely reattach rails to frame bracket.
From truck bed attach pucks and trim rings to rails (Figure 22) using 5/8" flat washer under the puck, button
16.
head screw and lock washer. Tighten to 100ft.lbs. torque.
Figure 22
5/8" FLAT WASHER
4 PLACES
17.
Insert puck plugs (as shown) whenever pucks are not in use. (Figure 23)
Install REESE
18.
19.
Torque hitch assembly bolts per hitch instructions.
Torque all 5/8" rail kit hex bolts to 170ft.lbs and 3/4" hex bolts to 260ft.lbs
20.
21.
Replace any brake lines and spare tire that may have been removed/relocated.
30868N – 5/23/14 REV. E
5/8" BUTTON HEAD
4 PLACES
5/8" LOCK WASHER
4 PLACES
PUCK
4 PLACES
TRIM RING
4 PLACES
Elite
Series fifth wheel per hitch assembly instructions.
PCN3694
©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
CAUTION:
installation.
DO NOT lubricate threads. It may cause bolt failure.
Truck Bed
Puck Plug
Puck Assembly
WARNING:
Figure 23
Printed in Mexico
10
Publicidad
