Protecting The Environment; Rechargeable Battery Pack - DeWalt DCF620 Traducido De Las Instrucciones Originales

EngLIsh
of the screw slipping from the drive accessory when pressure
is applied.
To drive the fastener, place it on the bit, press the variable speed
switch and push the fastener into the workpiece with a smooth,
continuous motion. When the fastener is seated, the clutch will
disengage automatically.
1. Install bit tip in bit holder.
2. Adjust depth locator 1 .
3. Check for correct rotation, start screwdriver and place screw
on bit.
4. Contact work surface, applying forward pressure to drive
screw until depth locator contacts the work surface.
Screwgun will ratchet automatically, disengaging bit
from screw.
5. This depth sensitive screwdriver is suitable for driving
drywall screws.
For This Depth Sensitive Clutch Please Remember
• The bit will not turn until pressure is applied to the unit.
Push to engage.
• Trigger switch will not depress unless tool is in either
forward or reverse position.
Screwdriving with Collated Screws (Fig. E)
To drive collated screws the DCF6201/DCF6202 attachment
should be used. The magazine attachment allows for faster work
flow when driving multiple screws. Instruction for installation,
usage and cleaning of this attachment is included in the
attachment's supplied manual.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
32

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Nosecone Maintenance (Fig. A, C)
4
If the nose cone becomes hard to turn it may be
contaminated with drywall dust.
1. Remove nose cone from tool.
2. Rinse thoroughly with warm water while rotating both
screw depth adjustment collar
Never use oil or solvents.
3. Dry the nosecone completely before reattaching to tool.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
2 3
and locking collar .
WALT recommended
e