Trial Run - Ibx HM01 Manual Del Usuario

Trial Run

•
Make sure the required operating voltage and the power supply voltage match.
•
Ensure the socket is properly earthed.
•
Ensure the power is OFF.
•
Pour the liquid to be heated in a vessel; if a stirring mantle is going to be used place the magnetic
stirring rod inside the vessel.
•
Place the vessel on the working space.
•
Plug in the power cable and ensure the power is ON.
•
Set the desired temperature; the equipment will start working.
•
Observe the real temperature.
•
In the models with stirring (HM02 series), select the stirring speed.
•
Check the stirring rod.
•
Stop the heating and stirring functions and power OFF the equipment.
If the operations above cause no abnormalities, the device is ready to operate. Otherwise, the device may have
been damaged during transportation. In that case, please contact your supplier.
5. Operation
6.1. HM01: Heating Mantle
•
Place the heating mantle on a horizontal, flat, and stable surface leaving at least 30cm clear on each
side. Do not place it near any heat source.
•
Plug the equipment into a power source; the red pilot (1) will light up showing that it is connected to the
power and will stay lit whenever the equipment is connected to a power source.
•
Turn the temperature knob (2) clockwise until you hear a "click"; this shows the heating mantle is ON. To
adjust the temperature, keep turning the knob clockwise.
•
Green pilot (3) – Working – shows the temperature variation. Thus, the more intense the light is, the
higher the temperature of the sample is.
•
Placing the thermometer: Assemble the two parts of the rod and insert the rod in its support at the back
side of the equipment. Once the rod is placed, place the bosshead at the desired height, hold it with the
screw and place the thermometer clamp.
6.2. HM02: Heating Mantle with Stirring
•
Place the heating mantle on a horizontal, flat, and stable surface leaving at least 30cm clear on each
side. Do not place it near any heat source.
•
Connect the equipment to a power source.
•
Turn the Heat Knob (1) clockwise until you hear a "click"; this shows the heating mantle is ON. The
corresponding indicator will light up (2). To adjust the temperature, keep turning the knob clockwise
towards the desired temperature.
•
Turn the Stirring Knob (4) clockwise until you hear a "click"; this shows the heating mantle is ON. The
corresponding indicator light will light up (3). To adjust the stirring speed, keep turning the knob
Note:
• The power used must match the device's requirement.
• Make sure the power line is at a safe distance from the
heating mantel.
• In case of any fault, cut off the electricity immediately.
7