Turn On The Power; Start Icemaker; Install Kickplate - Dacor DYF42SBI Serie Instrucciones De Instalación

Installation instructions

Turn on the power

Master Power Switch

Start icemaker

Install kickplate

26 English
TBI_Dacor_Installation_DA68-03583A-03_EN.indd 26
Raise Grille Panel
Water Filter
Test Button
Supplied Kickplate
• Set the Master Power Switch to the "I"
(ON) position.
• Check to make sure power to
refrigerator is on by opening
refrigerator door to see if interior lights
are on.
• The temperature controls are preset
at 3 °C for the Fresh Food section and
-18 °C for the Freezer section.
• Allow 24 hours to stabilize before
making adjustments.
• Press the icemaker Test Button at the
upper part of the freezer compartment
for 2 seconds.
- After the ice tray rotates, it goes
back to its initial position. When it
completes its rotation and water
is supplied to the supply line, the
operation of the icemaker is normal.
• Discard the first full bucket of ice cubes.
• Locate the supplied kickplate (shipped
taped to the top of the refrigerator).
Install with 2 screws provided.
• The vented kickplate must remain
unobstructed for proper air flow.
2020-10-15 10:39:37