EDM Product 08764 Manual De Instrucciones página 24

Circular saw
Operation
Battery charger (Fig.1)
The lithium-ion battery can be charged at any time and will
not develop a "memory" when charged after only a partial
discharge. It is not necessary to run down the battery pack
charge before recharging. Remove the battery pack from
the tool when convenient for you and your job. You can
"top-off" your battery pack's charge before starting a big job
or long period of use.
Due to lithium-ion's fade-free properties, the only time it is
necessary to charge the lithium-ion battery pack is when
the pack has reached the end of its charge. To signal the
end of charge, power to the tool will drop quickly. Charge
the battery pack as needed.
Fig. 1
Charging the battery
This lithium-ion battery pack is shipped partially charged.
Before using it the first time, fully charge the battery pack. A
fully discharged battery pack with a temperature between
5°C and 35°C will charge in about 1 hour (See section
"Specifications").
Plug the charger adapter into power source. The green light
on the charger stand will illuminate, indicating the charger
is powered.
Slide the battery all the way into the charger stand until it
locks in place with a click. The red light on the charger stand
will illuminate, indicating that the battery is charging.
The red light will go off after charging is complete and a
green light will appear.
NOTE: Batteries may become warm while charging. This is
normal. If the battery is hot after continuous use in the tool,
allow it to cool down to room temperature before charging.
This will extend the life of your batteries.
WARNING: Always disconnect the battery pack from the
tool before any assembly, adjustments or changing
accessories.
Insertion and removal of rechargeable battery (Fig.2)
Depress the battery-release button located on the front of
the battery pack to release battery pack.
Pull the battery pack out and remove it from the tool.
Warning!
Always remove the battery
adjustments to the equipment.
Be sure to read the following information before you put the
cordless equipment into operation: • Charge the battery
pack with the charger. An empty battery pack requires a
charging period of approximately 0.5 to 1 hour.
INSTRUCTION MANUAL
EN
pack before making
Fig. 2
On/Off switch (Fig.3)
Use the On/Off switch and lock off switch to start the
machine and keep holding it for continuous operation.
The machine can only be started by depressing the lock off
switch first, preventing any unintentional operation.
To switch the machine off, release the On/Off switch.
Before putting the circular saw down, please make sure it
has stopped completely.
Fig. 3
CAUTION!
Always hold the machine by both hands.
Never start the machine with the blade in contact with the
workpiece. Start cutting only after the motor reached its full
speed. And always remove the machine from the
workpiece before switching it off
Never stop the blade by exerting pressure on the side of the
blade.
Always carry out a test run before starting work and after
every tool change! Always ensure that the tools are in good
condition, correctly mounted and able to turn freely. The
trial run should be at last 30 sec.
Fig. 4
Using the Parallel Guide Fence (Fig.4)
The parallel guide fence is an effective aid for cutting in a
straight line.
To set the cutting width, install the guide in the machine
and rotate the knob to the required width. Then lock the
guide in place.
REF. 08764