EDM Product 08764 Manual De Instrucciones página 25

Circular saw
Operation
Note: If the distance between the side of the work piece and
the cutting position is too wide, or the side of the work piece
is not straight, firmly clamp a straight board to the work
piece and use this as a guide.
Removing the saw blade
Before any work on the power tool, remove the battery.
To remove the saw blade, press the spindle-lock button in
deep and hold it in this position continuously.(Fig.5a) If
necessary, turn the spindle slightly with the free hand until
it locks into position.
Loosen the flange with hey key provided and then remove
the blade from spindle.(Fig.5b)
Fig. 5a
CAUTION!
Check the blade regularly during use. If it has been jammed
or is deformed, replace it!
Adjusting the cutting depth
For optimal quality of cutting, the saw blade should not
extend more than 3 mm below the workpiece.
To adjust the cutting depth (0-55mm), please follow below
steps:
1. Loosen the depth locking lever by hand.(Fig.6a)
2. Raise/lower the base plate and set the blade to the
required depth - as shown on the cutting depth
scale.(Fig.6b)
3. Tighten the depth locking lever.
Fig. 6a
CAUTION!
Always check the locking lever before working. A loose
locking lever may cause serious injury.
Adjusting the cutting angle
CAUTION!
When bevel cutting, cutting depth does not correspond
with value on cutting depth scale.
Always check the bevel adjustment lever before working. A
INSTRUCTION MANUAL
EN
Fig. 5b
Fig. 6b
loose adjustment lever may cause serious injury.
Adjust the cutting angle (0-45º) (Fig.7)
1. Loosen the bevel adjustment lever by hand.
2. Adjust the base plate and set the blade to the required
angle - as shown on the bevel angle scale.
3. Tighten the bevel adjustment lever.
Fig. 7
Dust suction
The dust extraction port to allow a dust extraction system or
a household vacuum cleaner to be connected to the tool for
a cleaner and safer work area.
Application advice
Please always properly secure the workpiece before
working.
For board cutting, please always fix the workpiece in a
support surface and make sure the blade can not touch
with it.
CAUTION!
Never cut the unsecured board!
Cleaning
Keep all safety devices, air vents and the motor housing free
of dirt and dust as far as possible. Wipe the equipment with
a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately
each time you have finished using it.
Clean the equipment regularly with a moist cloth and some
soft soap. Do not use cleaning agents or solvents; these
could attack the plastic parts of the equipment. Ensure that
no water can seep into the device. The ingress of water into
an electric tool increases the risk of an electric shock.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
STORING
Store the machine, operating instructions and where
necessary the accessories in the original packaging. In this
way you will always have all the information and parts ready
to hand.
Pack the device well or use the original packaging in order
to avoid transit damage.
Always keep the machine in dry place.
REF. 08764