Quick Start - DPM Dew Point Meter Manual De Instrucciones

Press the
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
1.Remove the protective rubber cap from the probe.
2.Power-up Gage by pressing the center navigation
A typical instrument screen is shown below, consisting of RH, Ta,
Ts, Td, and Ts-Td readings. This group of readings is referred to as
a dataset.
Introduction
Introduction

Quick Start

button to power up the Gage. To conserve battery
RH
Ta
Ts
Td
Ts-Td
Tw
V - Wind Velocity (DPM A model only)
- Relative Humidity (measured)
- Air Temperature (measured)
- Surface Temperature (measured)
- Dew Point (calculated)
- Surface minus Dew Point
Temperature (calculated)
- Wet Bulb Temperature (calculated)
(Advanced models only)
1
button.