Controller Use; How To Set The Duration Of The Dripping, Running And Stopping - Infrico DIXELL XH360L Empleo

1.3. OFF (STOPPING)
In the last period occurs the "repose" of the product, i.e., are left evolve chamber conditions stopping
regulation and fans, so that the water in the interior of the product has time to migrate to the surface of
product. The recommended duration of the repose period will depends on the type of product and the
quantity thereof, which may be necessary to vary the times. Programming that come the factory is a time
of repose (OFF) 1 hour.
In certain situations or with a lot loaded, you can cancel the repose time and is continuously drying
period. (SEE HOW TO SET THE DURATION OF DIFFERENT PHASES).
Once you have finished the repose period begins again another dry period and another repose
period, and so on, until you manually stop the cycle with the button ON/OFF. If you want, you can cancel
the dripping phase or repose phase just put the corresponding zero duration, which can be left alone
drying cycles that can continuously repeated over until manually stopped.
It is also possible that the controller perform a single cycle of the determined duration (up to 24
hours) and stop, this would require changing the "trc" parameter.
NOTE: As discussed the conditions programming and times is a proposal factory, but for the optimal
use of the machine, these conditions must be adapted to each specific product.

2. CONTROLLER USE

The appearance of the controller is the next:
START KEY
CLOCK KEY
2.1. HOW TO SET THE DURATION OF THE DRIPPING, RUNNING AND STOPPING PHASES
UP KEY
DOWN KEY
Page: 3 /6 Date: 06/04/16 Review: 01
SET Tª KEY LIGHT KEY
SET RH KEY ON/OFF KEY