Wilo Atmos TERA-SCH Instrucciones De Instalación Y Funcionamiento página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.2.1
Attaching the pump
Fig. 7: Do not lift at housing eye bolts
Installation and operating instructions Wilo-Atmos TERA-SCH
Transport and storage
NOTICE
Use only properly functioning lifting equipment!
Use only properly functioning lifting equipment to lift and lower the pump. Ensure
that the pump does not become jammed during lifting and lowering. Do not exceed
the maximum bearing capacity of the lifting equipment! Check that lifting equip-
ment is functioning properly before use!
CAUTION
Property damage due to incorrect transport
To ensure proper alignment, all equipment is pre-assembled. If dropped or if im-
properly handled, there is a risk of misalignment or deficient performance due to de-
formations. The pipes and valves will not withstand loads and should not be used to
secure loads in transit.
• Only use permitted lifting gear for transport. Ensure the stability of the load since,
with this particular pump design, the centre of gravity is shifted to the top (top-
heavy).
• Never attach lifting gear to shafts in order to lift the unit.
• Do not use the transport lugs on the pump or motor to lift the entire unit. They are
only meant for transporting the individual components during installation or dis-
mantling.
Only remove the outer packaging at the place of utilisation to ensure that the pump is
not damaged during transport.
CAUTION
Risk of damage due to incorrect packaging.
If the pump is transported again at a later date, it must be packaged so that it cannot
be damaged during transport. Use the original packaging for this, or choose equival-
ent packaging.
CAUTION
Incorrect lifting can damage the pump! Risk of falling!
Never lift the pump with slings engaged below the bearing housing. The eye bolts on
the pump top housing are only for lifting top housing during maintenance. Do not lift
complete pump with the eye bolts. Safe working load of wire ropes reduces with in-
crease in included angle. Never put down or pick up the product when it is not se-
cured.
ƒ
Comply with applicable national safety regulations.
ƒ
Use legally specified and approved lifting gear.
ƒ
Select the lifting gear based on the prevailing conditions (weather, attachment
point, load ...).
ƒ
Never feed the lifting gear over or through transport lugs without protection.
ƒ
Never feed the lifting gear over sharp edges without protection.
ƒ
Use lifting equipment with sufficient bearing capacity.
ƒ
The stability of the lifting equipment must be ensured during operation.
ƒ
To lift the bare shaft pump, pass the lifting slings beneath the hydraulic housing at
suction and discharge flanges (see lifting drawing).
ƒ
If chains are used, they must be secured against slipping along with protective cover
to prevent damage to the product, paint and/or injury to personnel!
ƒ
When using hoisting gears, ensure that a second person is present to coordinate the
procedure if necessary. For example, if the operator's field of vision is blocked.
ƒ
When lifting, make sure that the load limit of the lifting gear is reduced when pulling
at an angle. The safety and efficiency of the lifting gear is best guaranteed when all
en
17

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido