Testing And Adjustments - Heath Zenith SECUR360 9309 Manual Del Usuario

8. Caulk around the mounting plate and mounting surface with
silicone sealant (not included) (see Figure 8).
CAUTION: Failure to completely caulk around the light
fixture's mounting plate could result in water seepage into
the junction box.

TESTING AND ADJUSTMENTS

CAUTION: To avoid water damage and risk of electrical
shock, rotate the motion sensor so the RESET button faces
the ground when the installation is complete.
1. Turn on the circuit breaker and light switch.
Note: The motion sensor has a 1 minute warm up period before
it will detect motion. When first turned on wait for the red LED
indicator to start blinking slowly (1 minute).
2. Go to the App Store
"Secur360" app
sheet, "Connecting to your new SECUR360 device", for more
details.
3. Once step 2 is complete, open the SECUR360 app and log into
the account.
4. IMPORTANT: This light has two detection zones – the motion
sensing detection zone and the camera detection zone. Use the
live video from step 6 and the motion sensor to set up your light
and camera.
5. Click on the home screen icon
"Light" icon > click "Light Setting"
6. Click on the back arrow "<" in the upper left of the screen to view
a live video feed.
7. Walk through the coverage area noting where you are when the
lights turn on. Also, the LED indicator behind the motion sensor
lens will glow blue when motion is detected (see Figure 8). Note:
The blue LED will turn off 30 seconds after all motion has stopped.
8. If needed, gently grasp the motion sensor and move it from side
to side or up and down to the best position to pick up motion
and to view the desired area using the camera (see Figure 9).
9. If needed, gently grasp the top and bottom of the light panels and
tilt them up or down or side to side to adjust the light coverage
area (see Figure 10).
CAUTION: Heat sinks can be warm to the touch. Turn
light fixture off for 5 minutes before touching heat sinks.
210509-01
or Google Play™ and search for the
SM
and download. See the enclosed instruction
> click on the light > click
Home
To see operational and troubleshooting information and videos,
> click "Test".
go to www.hzsupport.com
Figure 8
Motion
Detection
Zone
Figure 9
Heat Sink
Figure 10
LED Indicator
Camera Zone
Motion Sensor
and Camera
Light Panel
5