Setting Up And Using Sports Tens 2; Charging The Battery - TensCare sports TENS 2 Instrucciones De Uso

When MEM D is displayed, use the + and -
buttons to select the day (shown on the left of
the screen).
Having selected the required date, press
+MENU or -MENU to cycle to MEM H ( to
display hour of individual recordings on that
date).
Then use the + and - buttons to view the
different recordings (up to 3 per day).
For each recording the hour is shown on the
right side, and the values are displayed for
MODE, PROGRAMME, Time of treatment in
minutes (0-99), and the average intensity (0-99)
used in each channel.
To clear the memory, press and hold the
+MENU and -MENU buttons together for 5
seconds while in memory mode MEM D or
MEM H.
12. SETTING UP AND USING
SPORTS TENS 2

12.1. CHARGING THE BATTERY

The Sports TENS 2 is powered by a built-in
rechargeable Li-ion battery. A charging adapter
is included in the kit. The battery should need
charging about once a month. The battery
should last at least 15 hours at 50mA, 300μs,
50Hz. To fully charge the battery it will take
about 2 hours.
When the battery is running low, the
low battery symbol will be displayed
on the screen. Although the display
fades as the batteries run down, the strength of
the output does not change until the warning is
shown.
Warning:
adaptor and charging cradle supplied.
Use only the power
Use of other chargers could be hazardous and
will negate the warranty.
To charge the battery:
Connect the charger to the unit and plug it onto
the mains socket.
The word BATT and three flashing lines will
show on the screen display – that means the
battery is being charged.
When the battery is charged, the word FULL will
display
Note: The device should be charged at least
once every 3 months to ensure the battery life
is maintained.
Note: The device cannot be used while being
charged.
Note: Charging voltage: DC 5V, charging
current: 90mA.
Note: Use
specifications.
Output: DC 5 V; 1A
Rated input voltage shall not exceed
240 V
Classification of protection against
electric shock: Class II
IP classification: at least IP21
The adapter need to comply with IEC
60601-1 or IEC 60950-1
Battery Warnings
This product is equipped with a Lithium-ion
battery. Failure to follow these instructions
could cause the lithium-ion battery to leak acid,
become hot, explode or ignite and cause injury
and /or damage:
28
adapters of the following