Menus; Automatic Setting Menu - MURPROTEC CTA Instrucciones De Uso

CTA4-Mode-d-emploi(A5)-2021 2/02/21 18:04 Page 45
Screen Contrast
Brightness
Basic settings
Back to original settings ?
!!! REPLACE FLOW RATE AND
TEMPERATURE SETTINGS !!!
Cancel
Confirm
Menu reached by pressing or when on main screen:
Choose a temporary forced flow rate.
Press BACK to cancel.
Choose duration in hours for a floaw
rate of X %

4. MENUS

To go to the menus, press .
Use and to change menu and to enter it..
Press to go back.
Remark: When a menu is idle for some 30 seconds, the system
automatically goes back to the previous screen and so on,
Screen :
until the main screen.

4.1. Automatic setting menu :

The system adjusts automatically the air flow and temperature requested
depending on either the regional weather forecast, if you have a connected
device, or autonomously, if you do not have the connected option. The system
can thus use hot or cold air in the best and most efficient way possible.
The air flow displayed is called the basic air flow.
The temperature displayed is the setpoint temperature.
Screen :
To change the values, go to "Change" and press
Depending on the configuration of your installation, the programme will recommend an air flow and temperature (You are
not required to take them into account).
Set the values wit and . Confirm with .
Settings:
Basic air flow: 10 to 100%
Setpoint temperature: 5 to 18°C
43