Information Texts And Error Messages; Information Texts; Error Messages - MURPROTEC CTA Instrucciones De Uso

CTA4-Mode-d-emploi(A5)-2021

6. INFORMATION TEXTS AND ERROR MESSAGES

6.1. Information texts

Indicator lights
Green on -
Red off
Green on -
Red flashing
Green on -
Red flashing
Green on -
Red off
Green of -
Red flashing
Green on -
Red on
If the unit is connected to the Internet:
Green flashing -
Red flashing
Green of -
Red flashing
Green on -
Red off

6.2. Error messages

Indicator lights
Green off -
Red off
Green off -
Red flashing
Green off -
Red flashing
Green off -
Red flashing
Green on -
Red off
If the unit is connected to the Internet:
Green on -
Red off
Green on -
Red off
Green on -
Red off
46
2/02/21 18:05
Text Explanation
Replace filter The filter is almost at the end of its life. It is time to order a replacement
in +- x days. filter.
Replace filter. The filter is clogged. It must be replaced.
Replace filter The filter is saturated and is no longer 100% effective. You risk damaging
immediately. your unit and soiling your home.
System failure!
--- T° TOO HIGH --- The temperature in the machine exceeds the limit set by the installer or is
--- T° TOO LOW --- below 3°C
--- FILTER --- Question asked when the filter is removed. Answer YES only if you have
-DID YOU REPLACE placed a new filter and cleaned the installation (see § 7)
THE FILTER?
--- MANUAL STOP --- See in the "Stop" menus (§4.4), the fan is switched off. Follow the
instructions to restart the appliance.
POLLUTION REPORTED The air flow is reduced as a precautionary measure and will go back to
IN YOUR REGION. normal when the alarm is lifted.
Risk of breakdown, The filter has exceeded its maximum service life. The machine has shut
change filter down as a safety precaution. Please install a new filter so that the machine
immediately. can be restarted.
ETHERNET: Connecting...
CONNECTION...
Text Explanation
No display Caused by a voltage drop or
(screen empty) power failure
--- NO FILTER --- There is no filter in the unit.
--- SPEED ERROR --- Speed reading problem.
--- T° ERROR --- Temperature reading problem.
RJ11 ERROR Communication problem
between the unit and its
control module
ETHERNET: The control module no
NO RADIO LINK longer communicates with
Etairbox
ETHERNET: No connection to server
NOT CONNECTED
ETHERNET: Server not responding
SERVER NOT
REPLYING
Page 48
Solution
Check that there is no power failure. The
unit is not affected.
Place a new filter (see § 7) or clean the
probe with an antistatic brush.
Call the number displayed on your control
module.
Call the number displayed on your control
module.
Contact our technical service
Check that Etairbox is powered (LED on)
Check that the control module is switched on
Bring Etairbox closer to the control module
Check that Etairbox is connected to the box (RJ45)
Check that the box is connected to the Internet
The Internet line may be out of order
Your machine is operating autonomously. We have
been alerted and are remedying it.