Electrical Connections; Fcc Notice - CREE LIGHTING C-Lite C-AR-A-AL Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
C-AR-A-AL Series
BACKLIGHT SHIELD
(Requires use of C-AR-A-AL-BCKLGTSHLD
Accessory)
Unfold backlight shield. See Figure 6.
1.
2. Slide backlight shield onto fixture housing, making sure flanges
with (4) slots are positioned on top of housing. See Figure 7.
3. Align (4) slots with holes on top of housing.
4. Thread (4) supplied screws through slots in backlight shield and
into housing. Tighten screws to 20 in-lbs. (2.5 N•m). See
Figure 8.

ELECTRICAL CONNECTIONS

Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
DIMMING
1. Grey (-) and violet (+) leads are for 0-10V dimming
systems. Cap off if not used or if dimming is being
controlled through 7-pin NEMA photocontrol.
NOTE: For dimming connections, use Class 1 wiring
methods only.

FCC NOTICE

CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
http://lighting.cree.com/warranty
Document LPN00851X0001A0_A
Created By: TMT
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
| 866.924.3645
Date: 03-03-2021