Using The Appliance; Remote Control - universalblue UVT1323-21 Manual De Instrucciones

3. Using a ruler you can check the blade route. Simply place the ruler
against the roof vertically, and note the distance from the edge of the
blade to the roof. Carefully spin the blades with your hand to check all
the blades. If the blades are not aligned, the holder can be slightly
bent up or down to align it with the rest of the blades.
If after following all these steps the problem is not solved, a small
adjustment must be made using the balance kid provided.
1. Turn the fan on and change the speed until the most noticeable swing
occurs (usually the highest speed).
2. Turn off the fan. Select a blade and place the balancing clip on the
edge of it, between the holder and the tip.
3. Turn the fan back on and see if the tilt has improved or worsened.
Turn the fan off and change the clip to another blade to check again.
Repeat this process for all blades and note which blade has the most
noticeable improvement.
4. Put the clip back on the blade where you noticed the greatest
improvement. Move the clip along the blade and turn on the fan to find
the position where the clip offers the better improvement.
5. Next, remove the clip and place one of the balance weights on the
point where the clip was placed. To do so separate the white sticker
with your fingernails or, if necessary, carefully use a knife or scissors.

4. USING THE APPLIANCE

This device is very easy to use and does not require much knowledge.
However, we advise you to familiarize yourself with the instructions below.
The fan has 3 power levels that can be selected through the remote control. It
also has a timer of up to 8 hours.

REMOTE CONTROL

The device incorporates a remote control, for a more comfortable and
efficient use.
In order for the remote control to work, it must always be aimed at the fan.
Before you start using it, please take a few minutes to familiarize yourself with
the functions:
Fan ON/OFF button
•
: Press it to turn the device on or off.
36