Connecting Water Supply Line And Power - LG SIGNATURE LUDP890 Serie El Manual Del Propietario

Connecting Water Supply
Line and Power
Connecting Water Supply Line
1
With the home water supply turned off,
connect the water supply line to the inlet valve
on the left front of the dishwasher.
CAUTION
• Tape or compound should not be used on
dishwasher inlet valve.
2
Tighten the compression nut.
3
Slide the water supply line back through the
channel, pulling gently from inside the cabinet
to make sure the line is not kinked, pinched,
stressed or crushed.
Connecting Power
The dishwasher should have a dedicated properly
grounded branch circuit to connect the 3 wire
setup which includes the ground wire.
If a 3-prong power supply is used, it should be in
an accessible location adjacent to the dishwasher
within 4 ft. (1.22 m) of the dishwasher side and not
behind the dishwasher.
NOTE
• The best location for the electrical conduit is
on the right side of the back wall. Re-route the
electrical cable before installation if the electrical
conduit pipe is longer than 3" (76 mm) and is
centered on the back wall.
1
Turn off electrical power to the unit at the
circuit breaker.
2
Use a Phillips screwdriver to remove the screw
from the junction box cover and remove the
cover.
3
Use a Phillips screwdriver to remove 2 screws
.
a
4
Remove the junction box from the appliance.
INSTALLATION 21