Levolor Roller Shades Fabric Instalación página 7

INSIDE MOUNT (IM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: Before marking bracket locations, ensure that your bracket placement
will not interfere with any components inside the headrail.
•
Verify that your window casing has a minimum
depth of 1 ⁄ " which allows for a partially recessed
3
4
headrail mount.
•
If flush mount (fully recessed mount) is
desired, a minimum mounting depth of
3" is required.
•
Mark approximately 1" from each
jamb for bracket location.
•
Mark screw locations for each end
bracket, 2 holes per bracket.
•
If more than two installation brackets
come with your order, space additional
bracket(s) evenly between the two end
brackets, no more than 30" apart.
STEP 2: INSTALLING THE BRACKETS
•
Pre-drill screw holes.
— If installing brackets into wood,
used supplied screws.
— If installing into drywall, use
anchors in combination with
supplied screws.
•
Screw in brackets at marked
locations, 2 screws per bracket.
•
Ensure all brackets are square
with each other.
Bracket
Bracket
Bracket
Bracket
Screw
Screw
Cordless Lift Control–Cassette Valance
INSTALLATION
7