Unilever UR5640 Manual Instrucción página 8

EN
2. Open the side panel of the main unit.
Step 1: Find the handle position at the bottom of the left side plate on
the main unit
3. Take out the expired filter
a. After turning off the inlet valve, lift the hoop of the expired filter to the full extent and keep this state unchanged.
b. Pull the hoop outwards and take out the Filter, and dry the remaining water with a towel.
4. Replace with a Filter
c. Remove the packaging of the new Filter.
d. As shown in Fig. , lift the hoop of the new Filter to the full extent and keep this state unchanged.

e. Insert the bottom of the Filter into the positioning hole of the Filter, then fixed the filter element until obvious resistance
is felt, and press down the hoop to the position shown by the dotted line in Fig.
f. Pull the Filter outward to check whether it is installed in place.
Note: After replacement, please flush the Filter according to the debugging method, and normal operation can not be carried
out until the debugging is completed.
Step 2: Pull outward along the direction indicated to open the side panel
.

Hoop of filter
- 8 -