Outside Mount; Important - Levolor Roller Shades Fabric Instalación

OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: The brackets must be flush against a flat mounting surface. Do NOT
mount brackets on curved molding.
•
Center the shade over the window opening at the
desired height.
•
Mark screw locations for each
L bracket approximately 3"
from end of cassette,
2 holes per bracket.
— Use a level to ensure all
brackets are aligned.
•
For the battery pack, an extra
shade bracket is provided and
should be positioned 6-10" from
the adjacent bracket.
•
If more than three installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart.
STEP 2: INSTALLING THE BRACKETS
•
Pre-drilling screw holes using a
marks as a guide.
— If installing brackets into wood, use
supplied screws.
— If installing into drywall,
use anchors in combination
with supplied screws.
•
Screw in L brackets at marked
locations, 2 screws per bracket.
•
Ensure all L brackets are square
with each other.
•
Add the battery mounting clips to the two brackets which will
hold the battery pack, which will be located on the far right
side of the shade.
•
Attach cassette mounting bracket to L bracket using screws and wingnuts.
— Make sure the release tab is always mounted on the bottom.
Bracket
Bracket
⁄ " drill bit, using pencil
1
16
Drywall
Screw
Anchors
Drywall
Bracket
Anchor Bracket
Motorized Control Lift–Cassette Valance
INSTALLATION
Screw
9