Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - Stainless Steel Installation
STEP 1 REMOVE PACKAGING
WARNING
The refrigerator is much heavier at the top than at
the bottom—be careful when moving. When using a
hand truck, handle from the side only.
• Carefully cut banding at the top and bottom,
remove the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE: IT IS NOT NECESSARY TO LAY THE
CABINET DOWN IN ORDER TO REMOVE THE SKID!
• The unit is secured to the skid with 4 slotted tie-down
straps. Remove the six 7/16" bolts from the base channels
in the tie-downs.
• Remove the six 7/16" bolts securing the straps to the skid.
6
Tip Over Hazard.
NOTE: DO NOT ATTEMPT TO ROLL UNIT OFF SKID.
• The support blocks
on the bottom of the
refrigeration case
must be removed
before the refrigerator
is taken off the skid
or damage will occur.
Carefully tilt the
refrigerator and slide
the blocks out from
beneath.
• Remove the toekick
and set aside for final
installation.
• Lift the refrigerator
off the skid with an
appliance dolly. Handle from the sides.
Remove 5
base channel
bolts on each
side
Remove 2 strap
bolts on each side
31-1000543 Rev. 0
Publicidad
Tabla de contenido
