Cafe CDB36 Manual De Instrucciones página 8

Ocultar thumbs Ver también para CDB36:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions - Stainless Steel Installation
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system
If the water supply to the refrigerator is from a
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Filter Bypass Plug
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4" (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
8
STEP 4 ANTI-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure
up 81 1/2"
(207.01
cm) from
the floor.
Mark this
point on
the wall.
• Using
a level,
draw a
horizontal
line on the
wall at this
height.
• Locate at
least 2
studs on
the back
wall. Mark
these
points on
the horizontal line.
Tip Over Hazard.
31-1000543 Rev. 0

Publicidad

Tabla de contenido
loading

Tabla de contenido