Electric Shock Hazard - Cafe CDB36 Manual De Instrucciones

Ocultar thumbs Ver también para CDB36:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions - Stainless Steel Installation
STEP 2 INSTALL WATER LINE
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING

ELECTRIC SHOCK HAZARD

Attach tubing clamp using existing hole only. DO NOT
drill into the refrigerator.
• A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40
and 120 p.s.i.
(275-827 kPa).
• Route 1/4" OD copper
SmartConnect
plastic
tubing between house
cold water line and the water connection location.
• Tubing should be long enough to extend to the front of
the refrigerator. Allow enough tubing to accommodate
bend leading into the water line connection.
NOTE: The only Cafe-approved plastic tubing is supplied
in the SmartConnect
Refrigerator Tubing kits. Do not
use any other plastic water supply line because the line
is under pressure at all times. Other types of plastic may
31-1000543 Rev. 0
crack or rupture with age and cause water damage to
your home.
SmartConnect
the following lengths:
2' (.6 m) - WX08X10002
15' (4.6 m) - WX08X1 0015
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the line
of water.
• Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
• Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into a
bucket. Shut off water supply at the shut-off valve.
Floor
or
NOTE: Saddle type shut-off valves are included in many
Waterline Tubing
water supply kits, but are not recommended for this
application.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
Refrigerator Tubing Kits are available in
8' (2.4 m) - WX08X10006
25' (7.6 m) - WX08X10025
7

Publicidad

Tabla de contenido
loading

Tabla de contenido