Assembly And Operation; Removal And Installation Method Of Battery; Charging Method - Metabo HPT C 18DBAL Manual De Instrucciones

English
APPLICATIONS
○ Cutting various types of wood.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 6).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 6).
Insert

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. <UC18YSL3>
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
<UC18YFSL>
Connect the charger's power cord to a receptacle.
When the power cord is connected, the pilot lamp will
blink in red. (At 1-second intervals)
12

ASSEMBLY AND OPERATION

Handle
Latch
Push
Battery
Pull out
Fig. 6
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 7.
Battery
Charge
indicator lamp
Guide rail
<UC18YSL3>
3. Charging
<UC18YSL3>
When inserting a battery in the charger, the charge
indicator lamp will blink in blue.
When the battery becomes fully recharged, the
charge indicator lamp will light up in green. (See
Table 2-a)
● Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 2-a, according to the condition of the
battery charger or the battery.
<UC18YFSL>
When the battery is inserted into the battery charger,
charging will commence and the pilot lamp will light in
red. (See Table 2-b)
NOTE
If the pilot lamp does not light or blink in red, pull out
the plug from the receptacle and check if the battery
is properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2-b)
Pilot lamp
Charger
<UC18YFSL>
Fig. 7
Battery