Metabo HPT C 18DBAL Manual De Instrucciones página 21

Always-ON
mode
Panel
ON
display
ON
OFF
Always ON
(turn off after
2 minutes)
State
CAUTION
Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
7. Attaching the guide (sold separately)
Slide the guide through the front hole on the side of
the base (the cut-off side). Move the guide to the right
or left to adjust the cutting position, and tighten the
wing-bolt at the front to fasten the guide.
Guide
Table 7
SW Always-OFF
interlocked mode
mode
ON ON
ON ON
OFF OFF
Light only Always OFF
SW-ON
(Automatically
goes out
approximately
10 seconds
after the
switch is
released)
Wing-bolt
Fig. 24
8. Attaching the long guide (sold separately)
You can cut at a greater degree of parallel angle
against the end face of materials than the regular
guide.
When using the long guide, use the wing-bolts at the
front and rear.
(1) Normal installation
a) Slide the front and rear guide bars through the
holes on the base side and move the long guide to
the right or left to adjust the cutting position.
b) Press the front guide bar against the indicated
direction and tighten the front wing-bolt. Then,
tighten the rear wing-bolt to fasten the guide bar.
c) Lay the front of the long guide along the material to
cut.
Front wing-bolt
Front guide bar
Rear wing-bolt
(2) Installation to the housing side
Use by re-installing the two front and rear guide bars.
a) Remove the two screws of the long guide.
b) With the protrusions of the long guide pointing
downwards, re-attach the two guide bars.
English
Long guide
Rear guide bar
Fig. 25
Fig. 26
21