Kärcher MV 3 Manual Del Usuario página 17

Wet vacuum cleaning

For vacuuming up moisture or wet-
ness pay attention to the correct
floor nozzle insert and connect the
corresponding accessories.
Caution:
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.
Working with electrical power
tools
Illustration

Adapt the adapter to the connection
diameter of the electric tool using a
knife if necessary.

Connect the adapter to the handle
of the suction hose and connect it to
the electric tool connection.
Connect the mains plug of the elec-
tric power tool to the vacuum clean-
er.
Illustration

Switch the vacuum cleaner to Posi-
tion II and start working.
Note: As soon as the electric tool is
switched on, the suction turbine starts
with a 0.5 second delay. If the electric
tool is switched off, the suction turbine
continues to run for approx. 5 seconds
in order to vacuum up the remaining
dirt in the suction hose.
Blowing function
Cleaning hard to reach locations or,
where vacuuming is not possible, like
leaves from a gravel bed.
Illustration

Connect the suction hose to the
blower connection, this will activate
the blower function.
Interrupting operation

Turn off the appliance.
Illustration

Hook the floor nozzle into the park-
ing position.
Finish operation

Turn off the appliance and discon-
nect the mains plug.
Empty the container
Illustration

Remove the appliance head and
empty the reservoir.
Storing the appliance
Illustration

Stow away the mains cable and ac-
cessory at the machine. Store the
appliance in a dry room.
EN
– 10
17