ShenPaz Focus 4010 Manual De Instrucciones página 13

EXAMPLE 1
Entering a START TEMP of 400C and HEAT RATE 55C/min.
Arrow key until the
1. Press the
2. Press the keys [4], [0], [0].
3. Press the Arrow UP key until the HEAT RATE display will be illuminated (do not
enter values in the UP TIME and DRY TIME fields if not needed).
4. Press the keys [5], [5] for the ramp.
5. Press ENTER key.
EXAMPLE 2
Entering a UP TIME and DRY TIME of 3.5 minutes each.
1. Press the arrow key until the [UP TIME] field will appear
2. Press the keys [3], [3], [0].
3. Press the up key.
4. Press the keys [3}, [3], [0].
5. Press the key [ENTER] or Arrow key again.
EXAMPLE 3
Entering a "VACUUM ON" TEMP of 420C, "VACUUM OFF" TEMP 820C and
"VACUUM LEVEL"
of 720mmHg.
1. Press the up key until the Field "V on" will be displayed on the "VACUUM" field.
2. Press the keys [4], [2], [0]. For vacuum start
3. Press the up key until the field " vacuum off" will be displayed on the "V.off"
display. For the end of the vacuum
4. Press the keys [8], [2], [0].
5. The vacuum Level can be set here or by preset the Level in the option screen, if
the Level is chosen this possibility will not appear, if the fields in the option is
empty, you will be able to set the vacuum level
if the field is enable than
6. Press the keys [7], [2], [0].
7. Press the key [ENTER] or arrow key again.
FOCUS 4010/HT Dental Porcelain Furnace
field will appear
[START TEMP]
Page 13 Manual version 20.08.2015