General Description; Connections And Controls; Control Keys; Programming Keys - ShenPaz Focus 4010 Manual De Instrucciones

2. General Description

2.1

Connections and Controls

1. Data keys

2. Control keys

3. Programming keys

4. LCD color
5. Temperature and Data Display
6. Vacuum Display
1. Power switch
2. Emergency wrench inlet
3. Muffle fuse
4. RS 232 /USB Inlet for Software
uploading
5. Power cord outlet
6. Power muffle fuse
2.2 Data Keys
Data keys are for the inserting, deleting, and changing of data.
The Data keys are:-
2.3 Control Keys :
The 4 control keys are:-
2.4
Programming keys:
PROG -
(PROGRAM)
ARROWS keys
FOCUS 4010/HT Dental Porcelain Furnace
FRONT PANEL:
The furnace controls are located on the front panel and are
divided into 6 sections:
REAR PANEL
The main switch and the furnace connections are located on the rear
panel.
 From numbers 0-9.
NUMBERS
 Confirms the selection of a program or a parameter.
ENTER
 Cancels the previous key selection.
CLEAR
 Turns the furnace on/off.
ON/OFF
 Switching to Idle mode.
STOP/LIFT  Raising and lowering the platform.
 Interrupting a firing cycle.
 Starting a firing cycle.
START

 Temporarily "freezes" the firing cycle.
HOLD
 Sets the furnace into the mode for program selection.
Closing and opening the table and toggle between the
different parameters in the editing mode
7. Calibration inlet
8. Vacuum pump inlet
9. Vacuum pump fuse
.
Page 7 Manual version 20.08.2015