Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Your Bath (cont.)
NOTE: An automatic purge cycle will begin approximately 30 minutes after the blower motor has
stopped. To activate the purge cycle sooner, manually initiate the purge mode.
Exiting the Bath
Push the door switch and open the toe tap drain. The water will drain from the bath in
approximately 2 minutes.
When the water level is below the level sensors, the door seals will automatically deflate. Periodic
cleaning of the sensors will improve response time.
To lower the door, grasp the handle and squeeze while lightly pushing down.
If the bath does not function properly, please refer to the "Troubleshooting" section.
NOTE: In the event of a power outage, your bath will not function. The door will not lower until power
is restored. Assistance may be required to exit the bath. To avoid this possibility, consider installing an
Uninterruptible Power Supply (UPS) as described in the installation guide.
1128535-5-G
6
Kohler Co.
Publicidad
