Instruction Manual - AKO-Agrartechnik BA-1199 Manual De Instrucciones

Operating Instructions
1
4
Description of function
Put the equipment into service by connecting to fence and earth first, then to a 12 V battery. Please check for
correct polarity of the connection (red="+", black = "-").

If only the green light is flashing, the equipment and battery are working correctly.

If the red and green lights are flashing simultaneously, the battery is in a low charge state. Although
pulses are still emitted to the fence, the back-up battery should be recharged in the very near future

If only the red light is flashing, then the deep discharge protection has kicked in (This is necessary to
protect the battery from permanent damage). The equipment no longer emits pulses to the electric
fence. Recharge or replace the battery immediately.

If neither of the two lights is flashing, the equipment is not getting any current from the battery (Check
the battery connection for correct polarity and the battery for sufficient voltage. If both are o.k., have
the unit checked by an expert.

The equipment gives no warning if the electric fence is faulty.
Important Notes:
The appliance must be installed in vertical position with the battery connecting cable at the bottom and, if
possible, protected against rain, see above picture. In case of wall mounting, the appliance must be mounted
against a fireproof wall. For outdoor installation, a zinc-plated metal casing can be used. This accessory (part
No. 44656) protects the appliance and simultaneously protects the accumulator.
Ensure correct polarity when connecting the battery ( red + and black - ).
!!! Attention: Earthing rods are not included in the scope of supply!!!
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system
regularly, in accordance with the conditions of use, at least once per day.
visual check of the appliance and the fence system
-
measurement of the minimum voltage of 2500V at each point of the fence
-
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, battery care,
warranty terms and conditions, and potential fault sources!
SERVICE Addresses:
Please contact your specialist dealer
2
Possible current sources:
12 Volt/ special 230 Volt
mains-adapter, for indoor use only!
(Art.-Nr.: 371023).
This energizer shall not be used
as an animal trainer (inside a barn).
3
5
Warning lights
1
(green and red)
3
2
Fence connection
Earth connection
3
12V battery connection
4
cable/ 230V mains adapter
5
Fastening hole
-EN-
Version : 2017.3