AL-KO GS 3,7 Li Multi Cutter Manual De Instrucciones página 14

Danger - risk of injury!
Turn off the device when carrying out mainte-
nance work. The blades continue to move after
the motor has been switched off.
„ After cutting work, thoroughly clean the device with
a hand brush or a cloth.
„ Do not hose down the device with water! Water in-
gress can damage the switch as well as the battery
and the electric motor.
„ Regularly check the cutter blade for damage.
Replace stumps or damaged cutting blades before
using it for the next time.
„ Treat the cutting blade with oil or a lubricating spray
after each use. Switch on the device briefly to distrib-
ute the oil better.
„ Professional inspection is necessary:
If the motor is blocked
„
If the cutting blade is bent or damaged
„
If the battery is damaged or drained
„
Transport
The battery has been tested according to the UN manual.
This is why the battery is not subject to the national and
international regulations concerning hazardous goods,
whether as individual item or when fitted to the device.
Fault remedy
Wear working gloves during all maintenance work!
Fault during operation
Reduced motor
performance
The motor power fades
although the battery is
displayed as being fully
charged
Battery does not charge
If faults are not listed in this table or you are unable rectify them yourself, please consult our customer
service department.
474 168_a
Possible cause
Cutter blade is blunt
Battery defective
Battery defective
„ Only transport the battery in the device.
„ Regulations in relation to hazardous goods may ap-
ply when transporting several batteries.
„ Never carry the device by the cutting blade.
„ Only transport the device with the blade protection
attached.
Disposal
Do not dispose of worn-out devices, batteries or
rechargeable batteries in the household waste!
Packaging, device and accessories are made of recycla-
ble materials and are to be disposed of accordingly.
„ The user is obligated to return the batteries and
accumulators. The device can be disposed of at
the dealer or at a waste disposal centre.
„ Integrated batteries can only be removed for
disposal.
„ Removing the batteries:
Discharge the device fully
„
Take all screws in the housing
„
Open the housing
„
Disconnect the connections to the battery
„
Take out the battery
„
Recycle the battery in an environmentally-friendly manner.
Solution
Replace blade stumps with original parts
Consult AL-KO customer service
Consult AL-KO customer service
EN
14