Publicidad
Idiomas disponibles
Idiomas disponibles
AUTOMATICALLY ADDING A LOCK
1.
Select Wizards tab on the left-hand side of the
screen. (See Figure 6)
Figure 6
2. Select Create Lock Database and click Next.
3. Select Add a new lock and follow the auto
configuration steps.
MANUALLY ADDING A LOCK
1.
Select Lock/User Editor tab on the left-hand side of
the screen. Select Lock Editor tab on top left of new
screen. (See Figure 7)
Figure 7
PAGE 3 OF 18
OPERATION CONTINUED
2. Select Add Lock. Enter a custom lock name for the
3. Enter a custom location for cabinet. Nothing needs
4. Select Pushbutton for Access Type.
5. Select Latch Configuration:
lock. Enter the serial number and setup code found
on the green sticker that arrived with flash drive.
(See Figure 8)
Figure 8
to be entered for manufacturer.
a. Select single latch for latch hardware.
b. Access Behavior: Set the amount of seconds the
lock remains in the open position after a user
enters a correct PIN.
c. Select if lock will recognize passage mode and if
dual credential users do not require PIN. Neither
option is selected as a default.
d. Passage Mode: The lock will remain unlocked
until another passage mode PIN is entered.
Create passage mode users and PINs in Lock/
User Editor tab. For a passage mode user to
set the lock into passage mode, user must enter
their PIN and press Enter on keypad. While lock is
unlocked press Enter on keypad again.
e. Dual Credential: Two PINs are required for user to
enter the cabinet. Primary PIN must be entered
first. If this box is not selected, dual credential
users will require 2 PINs.
f. Select Standard Latch for Latch 1 type.
0221 IH-9015
Publicidad
