Locating The Equipment; Mechanical Installation - Parker DME012 Manual De Instrucciones

3.2 Locating the equipment

Identify a suitable location for the equipment taking into consideration the minimum space requirements for maintenance and lifting equipment.
When considering the final location of the equipment take into account the noise generated when in use.
The dryer can be free standing or secured to the floor via the fastener points provided in the base.

3.3 Mechanical Installation

Once the dryer has been located into position install the piping and filtration for connection to the inlet and outlet manifold. AA and AO grade
filtration is required at the dryer inlet and a AR grade filter at the outlet as shown in diagram A5 of Annex A.
Ensure that each filter condensate drain is suitably piped away and any effluent is disposed of in accordance with local regulations.
Ref
1 General purpose filter (AO Grade)
2 High efficiency filter (AA Grade)
3 Dryer
The Dewpoint Dependent Switching (DDS) system requires a sampling point to be inserted into the piping between the AR grade outlet filter
and the isolation valve as shown in diagram A5. This sampling point should be linked to the 4mm push in connector of the DDS system using
P.T.F.E tubing.
It is important to ensure that all piping materials are suitable for the application, clean and debris free. The diameter of the pipes must be
sufficient to allow unrestricted inlet air supply to the equipment and outlet gas / air supply to the application.
When routing the pipes ensure that they are adequately supported to prevent damage and leaks in the system.
All components used within the system must be rated to at least the maximum operating pressure of the equipment. It is recommended that the
system be protected with suitably rated pressure relief valves.
Description Ref Description
4 Dust filter (AR Grade)
Feed line
5
(Optional with DDS)
6 Isolation valves
8
EN Installation & Commissioning