Installing Batteries; Technical Data - CST/BERGER Lasermark 58-MP3 Manual De Instrucciones

Using the Laser to Level. Set the unit on a surface that is
at a convenient height for marking a level reference plane
on walls or other surfaces. The laser will generate a
horizontal point of reference onto the surface.

INSTALLING BATTERIES

Open the battery cover. Slide the battery compartment open.
Remove used batteries. Place fresh batteries in the
compartment, aligning them according to the label
Check for correct polarity.Do not use rechargeable batteries!
Extreme temperatures and the use of batteries with different
levels of charge can reduce the operating time of the instrument.
Always use batteries with the same power rating and from the
same manufacturer.

TECHNICAL DATA

VISIBILITY RANGE: up to 100-ft (30 m) according to the light conditions
SELF-LEVELING RANGE: ± 5° in any direction
INDICATING LIGHTS: Low power: Laser blinks 8 times between 8 second intervals
LASER OUTPUT: Class 3R, 1 laser diode, 630–670 nm.
OPERATING TEMPERATURE: 32°-104°F (0°-40°C)
TRIPOD MOUNTING: 1/4-20
ENVIRONMENT:
ACCURACY: Plumb Up: ±1/4-in @100-ft (± 3mm @ 15m)
Level: ±1/4-in @100-ft (±3mm@ 15m)
Plumb Down: ± 1/4-in at 50-ft (±6 mm at 15 m)
Out of level: Laser blinks quickly
POWER: 3 "AA" batteries 1.5 V
0.8-1.0 mW each for class 2M;
0.8-2.5 mW for class 3R, each
WEIGHT: 1.2lb (545g) with batteries
IP 54 Dust and Water Protection
MP3 • 5