Troubleshooting Tips - Würth WPS 12-700 Traducción Del Manual De Instrucciones De Servicio Original

Fault
Vehicles can not be remote
started with the device.
The device batter is not
being charged.
The device shows a charge
of 100% but the ellow LED
is still lit up on the charger
(charging).
The red LED on the charger
is lit up.
The red LED on the charger
is ashing.

Troubleshooting Tips

Possible cause
The terminals do not indi-
cate su cient connection
with the batter .
The device is not charged.
Die vehicle batter is
defective.
The fuse is defective.
The batter is defective.
The device batter is not
completel charged.
There is not a su cient
connections between the
charger and the Power
Start.
Defective batter (does not
charge up an -more).
The charger is in abort
mode.
Remedy
Check whether, the terminals are correctl connect-
ed with the vehicle batter and the vehicle chassis.
Ensure that the connection points are clean (grease
and corrosion free).
Move the clamp back and forth to provide better
contact.
Check the batter charging state b pressing the
button at the front of the device (see section Check
charging state).
Have the batter checked.
Replace the fuse.
Have the batter checked.
Charge the batter until the green LED on the
charger lights up.
Check the connection Check that the connection
points are clean.
Have the batter checked.
See chapter LED indicator and display
19