Steren MUL-016 Manual De Instrucciones página 18

Transistor tester
Approximately voltage in direct way, test short / open and good / faulty.
Test voltage: 2.8 V---
Test current: 1.5 mA MAX.
Measurements hFE to value transistors (NPN or PNP).
Operation
With this meter we can check the battery status. If one battery have not
enough energy, you will see "LOBAT" or "BAT" in the LCD screen.
The symbol ! indicates that the voltage or the current must not exceed the
indicated values. It is used to prevent damages in the internal circuits. Before
to measure, we should choose the correct range.
Measuring DC / AC voltage
1.- Connect the red testing point to the jack signaled "V Ohms mA" and the
black testing point to the jack signaled "COM".
2.- Set the dial to the VDC / VAC setting . If you see "1" in the display, it
means the measured voltage exceed the selected range. Please, select a
higher one.
6