Hisense HGO601BS Manual De Funcionamiento Para El Usuario página 27

Take particular care handing the spark
plug wires and the thermocouple pipes
Replace all the parts, following the steps
described above in the reverse order
Regulating the primary air for the oven
burner
b) The burner was designed not to need any
adjustments to the primary air.
Minimum regulation of the oven door
c) Regulate the oven burner minimum:
Turn the knob first to the Max setting for about
10 minutes and then to Min;
Remove the knob
Remove the disk fastened to the control panel
Adjust the screw located outside the thermostat
cock pin until the flame is small but steady ( the
flame can be seen through the slots on the oven
bottom)
N.B.: In this case of liquid gas, the regulation
screw must be screwed in all the way.
Check that the burner does no turn off when you
turn the knob from Max to Min quickly and when
you open and close the oven door quickly.
Warning
On completion of this operation, replace the old
drating sticker with one indicating the new type of
gas used. This sticker is available from our Service
Centers.
Note Should the pressure of the gas used be different
(or vary) from the recommended pressure, it is
necessary to fit a suitable pressure regulator onto the
inlet pipe ( in compliance with the current National
Norms regarding "regulators for channeled gas"
- 13 -