Tripp-Lite NetDirector B020-008-17 Manual Del Propietário página 18

7. OSD (On-Screen Display) Operation
Setting
SET QUICK VIEW
PORTS
SET ACCESSIBLE
PORTS
RESET STATION
IDS
FIRMWARE
UPGRADE
SET CONSOLE
MODE
Function
Allows the Administrator to select which Ports are to be Quick View ports.
To select/deselect a port as a Quick View Port, double-click the desired
port, or use the Navigation Keys to move the highlight bar to it, then Press
[Enter].
An arrow is displayed in the QV column on the Main Screen to indicate
that a port has been selected as a Quick View Port. The arrow disappears
when a port is deselected. If one of the Quick View options is chosen for
the LIST view (see F2 LIST, page 15), only a Port that has been selected
here will display on the List.
If one of the Quick View options is chosen for Auto Scanning (see SCAN/
SKIP MODE, page 12), only a Port that has been selected here will be
Auto Scanned. The default is for no ports to be selected.
Allows the Administrator to define a User's access to the computers in the
installation on a Port-by-Port basis. For each User, select the target Port
and press the [Spacebar] to cycle through the choices: F (Full access),
V (View Only), or blank. Repeat until all access rights have been set, then
press [Enter]. The default is V for all users on all Ports.
Note: A blank setting means that access rights have not been granted. The Port will
not appear on the User's LIST on the Main Screen.
The OSD settings will not correspond to a new configuration if the position
of one of the Stations in the daisy chain is changed. This function directs
the OSD to rescan the Station positions of the entire installation and
updates the OSD so that the OSD Station information corresponds to the
new physical layout.
Note: Only the Station Numbers get updated. All Administrator settings (such as Set
Accessible Ports, Set Quick View Ports, etc.), for all of the computers affected by the
change, have to be manually redone. The only exception to this is Port Names.
In order to upgrade the KVM's firmware (see pages 21-24), the Firmware
Upgrade Mode must be invoked.
This setting selects which consoles (internal/external) are enabled:
0 Both consoles enabled
1 LCD console only
2 External console only
Use the spacebar to cycle to the choice you want. The default is 0.
18