Handling; Installation (All Models); Water Connection; Steam Connection - Domus DHS-11 Instrucciones Generales Para Instalación

When handling the appliance, the following should be observed:
o
Current regulations and laws
o
Regulations concerning occupational risk prevention
- Safety clothing and gloves must be worn for protection against cuts and knocks and safety shoes
should be used to prevent against injury as a result of falling components.
- When handling and moving the appliance, appropriate tools and resources must be used.
- Any work to the interior of the appliance must be carried out by qualified and skilled personnel.
CAUTION! Inappropriate handling of the appliance may result in damage or injury.

6.1. Water connection

If only cold water is available, connect as shown in figure 1. Where hot water is available, connect as shown in
figure 2. If, in addition, decalcified water is available, connect as shown in figure 3 (Not available in Group E).
Fig. 1
A=Stopcock B=Filter C=Hose A.C.=Hot water A.F.=Cold water A.D.=Decalcified water
VERY IMPORTANT: Bleed water circuit prior to installation and fitting filters.

6.2. Steam connection

If steam is available, the water will be heated by direct injection. The connection diagram is shown in the figure
(Not available in Group E).
WARNING! Failure to fit the filters on the water and steam inputs will result in loss of cover under
guarantee for the corresponding components.
VERY IMPORTANT: Bleed steam circuit prior to installation and fitting filters.
After steam has been introduced into the machine for the first time, it is advisable for the steam hose nuts to be
re-tightened.

5. HANDLING

6. INSTALLATION (ALL MODELS)

Fig. 2
Required dynamic pressure: 2 ÷ 4 Kg/cm
Steam pressure: 2 ÷ 4 Kg/cm
2
.
A=Stopcock
B=Filter
2
.
Fig. 3
4