Adjustment Of The Minimum; Electrical Connection Of The Cooker Hob - Foster 4000 Manual De Instrucciones

INSTALLER INSTRUCTIONS
IMPORTANT: After adjusting for use with a gas that is different from the initial testing
one, replace the label on appliance housing with the one that corresponds to the new
gas type.

12. Adjustment of the minimum

Instructions for urban and methane gas
1. Light the burner and bring it to the minimum
position.
2. Remove the gas tap knob and turn the adjust-
ment screw [
tap rod (depending on the model), until a regular
minimum flame is obtained. When a two-way
gas tap is present [
screws for minimum gas flow adjustment.
3. Re-assemble the knob and verify burner flame
stability (when quickly rotating the hand from
maximum to minimum position the flame must
not shut off).
4. Repeat the operation on all gas taps.
Instructions for liquid gas (LPG)
Tighten the screw inside, or on the side of the tap (depending on the mode), rod
clockwise completely.

13. Electrical connection of the cooker hob

IMPORTANT: Before completing the following operation, always make sure that the
voltage and sizing of the power supply line correspond to the characteristics indicated
on the place located under the housing of the appliance. This plate must never be
removed.
34
] inside or on the side of the
Fig. 8
] there are two
see Fig. 12-13
Fig. 8: adjustment of the minimum