Operator's Maintenance - Clarke WASH&RINSE ErgoEX IMAGE 16 I/IX 120V Libro De Instrucciones

HOW TO CLEAN AN AREA OF CARPET
How To Clean A Larger Area Of Carpet
See figure 3.
To clean a larger area of carpet, follow this procedure:
1. Begin at the right-hand corner of the carpet.
2. Make a pass halfway along the edge of the carpet. Pull
the machine backward at a steady speed.
3. Move to the edge of the carpet. Make another pass next
to your first pass.
4. As you make more passes, overlap one inch of the
area already cleaned. Make each pass four inches
different in length to prevent making a line in the center
of the carpet.
5. Make more passes until half of the carpet is cleaned.
6. Move to the right hand corner of the carpet not yet
cleaned.
7. Make a pass halfway along the edge of the carpet.
8. As you make passes, overlap one inch of the area
already cleaned.
9. Make more passes until all of the room is cleaned.
CAUTION: Clarke will not be held liable for dam-
age to the carpet, or poor results because
of the operator's lack of ability.

OPERATOR'S MAINTENANCE

How to Empty the Recovery Tank
To empty the recovery tank, follow this procedure:
1. Turn all switches on the machine to the "O" position.
2. Position the machine over a drain or position a bucket
under the drain valve spout.
3. Turn the valve.
4. Close the drain valve.
CAUTION: The recovery tank is equipped with an
electric shut-off float switch. When the
recovery tank becomes full, all electri-
cal functions will automatically be shut
off. Turn the vacuum/accessory and
spray/brush switches to the off position
before emptying the recovery tank.
How to Empty the Solution Tank
1. Turn all switches on the machine to the "O" position.
2. Position the machine over a drain or position a bucket
under the drain valve spout.
Clarke ®
Operator's Manual (EN) - Image 16 I/IX 120V
ENGLISH
EN
- 9 -